Page 1 of 1

Beat Club ORST50 - pictures

Posted: Sun Dec 17, 2017 12:07 pm
by LD50
- as per thread in technical, I promised pics of the original as it came.

Arced octal, burned voltage dropper, replaced filter cap and unhappy looking screen resistors, replaced bias resistor, missing transformer bolt/screw, crack in the front panel where it had moved in the sleeve.

See the german studio inlet and the microphone input. Huge Pennine transformers

This has the input trimmer pot too:

Image

As my internet connection to the forum is a bit tenuous I will post pics a few at a time!

Re: Beat Club ORST50 - pictures

Posted: Sun Dec 17, 2017 12:14 pm
by LD50
Image
Image
Image
Image
Image

Re: Beat Club ORST50 - pictures

Posted: Sun Dec 17, 2017 12:24 pm
by LD50
I replaced all the incorrect/cooked parts, did a slow cap reform and soak tested.
Plate voltage on EL34s is 520-530v depending on bias, it is extremely quiet and has plenty of 'girth' breaks up around 7-8 on the dial

Image
Image
Image
Image
Image

Re: Beat Club ORST50 - pictures

Posted: Fri Jan 05, 2018 1:57 am
by yossarian83
Thanks for posting these. The pics are gorgeous!

Re: Beat Club ORST50 - pictures

Posted: Mon Jan 08, 2018 10:03 am
by doombass
That's one cool piece of history. Do you own it or did you service it for the owner?

Re: Beat Club ORST50 - pictures

Posted: Fri Jan 12, 2018 12:10 am
by LD50
I serviced it for the owner on its way from Germany to its new owner in Canada. I have another very slightly later one passing through soon for a check over and tune up, will be interesting to compare.
The thing that strikes me about these is the size of the transformers.