CR120h + 2 1960 lead cabs ohms
Posted: Sun Jun 02, 2019 7:38 am
Hey everyone,
I have a CR120H aswell as a full 1960 Marshall Lead stack, I am wondering if there is ANY WAY AT ALL to daisy chain the 2 8 ohm cabs wired both in series in order to obtain a load of 16 ohms
CR120h speaker output >
IN to Marshall 4x12. #1>
Out of Marshall 4x12. #1>
Marshall 4x12. #2
I know I'm the manual it says it only works with the X1 16 ohm cab, x2 16 ohm cabs or X1 8 ohm, but it mentions that they wouldn't recommend daisy chaining cabs mainly for if one of the speakers go down you loose all your signal BUT when the mention daisy chaining is that including the use of 16ohm cabs or 8ohm cabs?
Any help would be much appreciated
Also forgot to mention I have one cab that is modified to have an input and output plate on the back.
I have a CR120H aswell as a full 1960 Marshall Lead stack, I am wondering if there is ANY WAY AT ALL to daisy chain the 2 8 ohm cabs wired both in series in order to obtain a load of 16 ohms
CR120h speaker output >
IN to Marshall 4x12. #1>
Out of Marshall 4x12. #1>
Marshall 4x12. #2
I know I'm the manual it says it only works with the X1 16 ohm cab, x2 16 ohm cabs or X1 8 ohm, but it mentions that they wouldn't recommend daisy chaining cabs mainly for if one of the speakers go down you loose all your signal BUT when the mention daisy chaining is that including the use of 16ohm cabs or 8ohm cabs?
Any help would be much appreciated
Also forgot to mention I have one cab that is modified to have an input and output plate on the back.