Thunderverb 200 to PPC412

Orange Amps Technical Q&A's

Moderator: bclaire

Post Reply
New Member
Posts: 5
Joined: Tue Apr 03, 2018 6:06 am

Thunderverb 200 to PPC412

Post by markus2018 » Fri Apr 13, 2018 2:23 am


Just a quick question. Am using a TV200 into a PPC412 at 100w 16 ohm and it sounds great.

If I wanted to run at 200w to trial different sounds this creates creates an impedance mismatch - 8 ohm amp to 16 ohm cab.

Is there any risk to the amp’s transformerss doing this? Most literature says this type of mismatch is safe.

I would not run the attenuators above half anyway so am assuming speakers will be fine.

Thanks for any advice.

Post Reply

Who is online

Users browsing this forum: No registered users and 3 guests