I have fitted a OV4 to a used RV100 MKii I have bought.
I have revalved it and want to set the bias as factory standard.
The OV4 I also bought seperate as used.
It is currently set at 30ma which seems awful low to me.
Can anyone message me or tell me the factory standard bias or a very close example.
I was guessing hi 30`s might be nearer but would prefer as near to factory as possible.
Thanks in advance.
Cheers
Just to add it is EL34 not a 6l6 transplant of tubes.
Factory Bias setting needed ? Fitted a OV4
Moderator: bclaire
Re: Factory Bias setting needed ? Fitted a OV4
Cheers I will reset the standard to that and then tweek. The custom feature and see if I notice any difference with different valves.
Who is online
Users browsing this forum: No registered users and 82 guests