changing speakers (celestion heritage)
Posted: Wed May 06, 2009 8:31 am
I am swapping the V30s in my two 2x12 Orange cabs with G12M and G12H Celestion Heritage.
The Heritages have to been soldered and they have two pins: one red and one black. So, to which pin do I have to chain the other speaker and to which one do I have to solder the input jacks?
V30s have two pins but they have the same colour... maybe one has the "+"...
One bonus suggestion : )
I am thinking to load one speaker with G12H (the lower one) and one with G12M (the upper one). Or is it better to load the cabs with a mix?
G12M are 20W and G12H are 30W, I use it with an OR50 head at about half volume, or without master volume with an attenuator.
What would you do?
The Heritages have to been soldered and they have two pins: one red and one black. So, to which pin do I have to chain the other speaker and to which one do I have to solder the input jacks?
V30s have two pins but they have the same colour... maybe one has the "+"...
One bonus suggestion : )
I am thinking to load one speaker with G12H (the lower one) and one with G12M (the upper one). Or is it better to load the cabs with a mix?
G12M are 20W and G12H are 30W, I use it with an OR50 head at about half volume, or without master volume with an attenuator.
What would you do?