buzzing reverb on rockerverb

jimbo · Post by **jimbo** » Tue Jul 13, 2004 9:13 am

i recently purchased an orange rockerverb 50 combo, but noticed that when the reverb is turned any more than half way (using either channel) there is a rather annoying buzzing that gets intolerable after 3/4. Is this normal? or is it just becuase its brand new? or is it a faulty reverb tube?

any ideas?

Andy H. · Post by **Andy H.** » Tue Jul 13, 2004 12:47 pm

Shouldn't buzz, jimbo. It's just possible that the reverb has been connected back to front, or gone faulty. Being brand new I'd check back with your dealer before doing anything else.

orangenoise · Post by **orangenoise** » Tue Jul 13, 2004 2:52 pm

Jimbo, I just got the RV Combo a couple of weeks ago. Definately no buzzing on the Reverb. One thing I did notice though, was if I did not let the tubes warm up for more than 3 minutes there would be some scratchy, static noise for about a minute until things settled. Now I just leave it on standby for about 5 minutes before switching it on and haven't had the issue since. Good luck with the reverb.

-orangenoise

buzzing reverb on rockerverb

Who is online