Orange Amps Technical Q&A's
Moderator: bclaire
-
bp2fl
- New Member
- Posts: 2
- Joined: Sat Jun 08, 2002 5:56 pm
Post
by bp2fl » Fri Aug 23, 2002 3:29 pm
I have a 140tc head and when i started using a footswitch sometimes when going from channel one to channel two, it would mute the amp instead of switch it. I thought it was a problem with the footswitch, so I took it back. Now it's starting to do it occasionally when i'm MANUALLY switching between channels. What's the deal? Any ideas?
Thanks!
Brian
-
bclaire
- Forum Moderator
- Posts: 17905
- Joined: Thu May 02, 2002 9:19 pm
- Location: Outside Boston MA, USA
-
Contact:
Post
by bclaire » Wed Aug 28, 2002 12:24 pm
sounds like the wrong type of footswitch- if it's a momentary one, then that's your problem. You need an on-off type. Billy
-
Just Blaze
- New Member
- Posts: 2
- Joined: Sat Aug 31, 2002 9:06 am
Post
by Just Blaze » Sat Aug 31, 2002 9:18 am
definatlly make sure that one or more of the pre amp tubes are not loose. my AD30TC used to do that before i checked them.
Who is online
Users browsing this forum: No registered users and 19 guests