140tc switching problems

Orange Amps Technical Q&A's

Moderator: bclaire

Post Reply
bp2fl
New Member
Posts: 2
Joined: Sat Jun 08, 2002 5:56 pm

Post by bp2fl » Fri Aug 23, 2002 3:29 pm

I have a 140tc head and when i started using a footswitch sometimes when going from channel one to channel two, it would mute the amp instead of switch it. I thought it was a problem with the footswitch, so I took it back. Now it's starting to do it occasionally when i'm MANUALLY switching between channels. What's the deal? Any ideas?

Thanks!

Brian

bclaire
Forum Moderator
Posts: 17905
Joined: Thu May 02, 2002 9:19 pm
Location: Outside Boston MA, USA
Contact:

Post by bclaire » Wed Aug 28, 2002 12:24 pm

sounds like the wrong type of footswitch- if it's a momentary one, then that's your problem. You need an on-off type. Billy

Just Blaze
New Member
Posts: 2
Joined: Sat Aug 31, 2002 9:06 am

Post by Just Blaze » Sat Aug 31, 2002 9:18 am

definatlly make sure that one or more of the pre amp tubes are not loose. my AD30TC used to do that before i checked them.

Post Reply

Who is online

Users browsing this forum: No registered users and 70 guests