Page 1 of 1

Double Footswitch cable question?

Posted: Wed Oct 02, 2019 4:13 am
by leeowensoas1
So controlling channel and reverb on my RV100 MKIII with an orange 2-button footswitch, could I use a double key TS cable like this?

https://www.sweetwater.com/store/detail ... -key-s-15r

Also if I wanted to throw just a single pedal in the effects loop could I use this?

Re: Double Footswitch cable question?

Posted: Wed Oct 02, 2019 3:25 pm
by Jondog
Yes and yes

Re: Double Footswitch cable question?

Posted: Wed Oct 02, 2019 9:07 pm
by Les Paul Lover
It's pretty pricey, but should do the job.


Bear in mind that for footswitches, the cables only transfer an electrical signal - no sound actually goes through it, so nothing is importany beyond cable reliability.

Got to admit, for a single pedal in the fx loop, that'd be neat..... but once you get one.... the 2nd might follow quite quickly..... :wink:

Re: Double Footswitch cable question?

Posted: Fri Oct 04, 2019 2:53 pm
by elvisdog
this will work just as well for the pedal:

https://www.amazon.com/Hosa-CPP-202-Ste ... _dp_1&th=1

and cost $13. Will it sound as good in the loop? I have a shorter one that I'm using to run a reverb in the loop of a Marshall Origin, and it sounds fine -- by which I mean the amp doesn't sound different at all as you switch the loop in & out, except for the reverb.