Footswitch experience

Orange Amps General Forum

Moderator: bclaire

Post Reply
Eenybear
New Member
Posts: 9
Joined: Sun Sep 09, 2018 11:23 pm

Footswitch experience

Post by Eenybear » Sun Sep 16, 2018 6:56 am

Hi

Today, I found a newish and sturdy. generic footswitch at a garage sale. I bought it with the hope it would work with the Orange Rocker 32. If not, I was planning to tweak the wiring to suit. Popped it open (6 screws) and saw the familiar component layout. Buttoned it up.

1. Set my Rocker32 to the dirty channel. 2. Used an extra regular instrument cable to connect the pedal.
3. Light came on with the distorted channel and went off with the clean channel.

I read posts where people say “it’s backwards because the light comes on with the clean channel”. Even with an FS-1. Easy fix - set the amp to the dirty channel before you start. 🤙

Works perfectly.
Hope this is helpful.
Ian

beninma
New Member
Posts: 11
Joined: Thu May 25, 2017 2:37 pm

Re: Footswitch experience

Post by beninma » Fri Sep 21, 2018 5:52 pm

With my Rocker 15 + FS-1 the light is on when you're on the dirty channel and the light is off when you're on the clean channel.

It sounds like you had it right the first time.

The switch on the amp needs to be set to the dirty channel for the foot switch to do anything. If the amp is set to "Natural" it stays on Natural no matter what you do with the footswitch.

Eenybear
New Member
Posts: 9
Joined: Sun Sep 09, 2018 11:23 pm

Re: Footswitch experience

Post by Eenybear » Wed Sep 26, 2018 7:20 pm

Thanks yes... I had read some comments on another site complaining about the switch light and started my journey with the amp on the dirty switch. Zero confusion and zero disappointments. Seemed counter intuitive so I thought I'd share. Pretty minor point, I know, but sometimes it's the little things that frustrate us. :)

Post Reply

Who is online

Users browsing this forum: No registered users and 23 guests