Daisy Chain - 3/4 stack
Posted: Thu Jan 12, 2012 4:22 pm
Long time lurker. First time poster. I've just scored a new orange 412 to go with my 212OB. I'll probably try to move by 212 soon; but in the meantime, I want to daisy chain them for a 3/4 stack.
I have a Tiny Terror and TH30. Both have 1 16 ohm output and 2 8 ohm outputs.
I assume to ensure everything is hooked up right I would go from either amp's 8 ohm output into CAB A's 16 ohm input. I'd then connect a second speaker cable from CAB A's second input into the 16 ohm input on CAB B. This would mean that both cabinets are running at 8ohms and since I've sent from the head's 8 ohm input I'd be ok....
Also, can I run speaker cables from the 2 8 ohm outputs on the head directly into both CAB A + B; thus eliminating the daisy chain?
I'm very new at this, so please forgive my ignorance. All I'm looking for is confirmation that this is correct. Thanks
I have a Tiny Terror and TH30. Both have 1 16 ohm output and 2 8 ohm outputs.
I assume to ensure everything is hooked up right I would go from either amp's 8 ohm output into CAB A's 16 ohm input. I'd then connect a second speaker cable from CAB A's second input into the 16 ohm input on CAB B. This would mean that both cabinets are running at 8ohms and since I've sent from the head's 8 ohm input I'd be ok....
Also, can I run speaker cables from the 2 8 ohm outputs on the head directly into both CAB A + B; thus eliminating the daisy chain?
I'm very new at this, so please forgive my ignorance. All I'm looking for is confirmation that this is correct. Thanks